Corvette parts, corvette rotors, corvette brakes, baer
Corvette Rotors, Including SCCA T1 HARBAR Racing Brake Parts.
Rotor
The disk rotor is made of iron with highly machined surfaces where the brake pads contact it. Just as the brake pads wear out over time, the rotor also undergoes some wear, usually in the form of ridges and groves where the brake pad rubs against it. This wear pattern exactly matches the wear pattern of the pads as they seat themselves to the rotor. When the pads are replaced, the rotor must be machined smooth to allow the new pads to have an even contact surface to work with. Only a small amount of material can be machined off of a rotor before it becomes unusable and must be replaced. A minimum thickness measurement is stamped on every rotor and the technician doing the brake job will measure the rotor before and after machining it to make sure it doesn't go below the legal minimum. If a rotor is cut below the minimum, it will not be able to handle the high heat that brakes normally generate. This will cause the brakes to "fade," greatly reducing their effectiveness to a point where you may not be able to stop!
New Products For April
From $99.99 to $199.99
From $199.99 to $499.99
From $499.99 to $999.99
From $999.99 to $10,000.00
$10,000.00 and above
|
|  |
| |
- Shopping Cart 0 items
| |
C6 "CORVETTE" Mirror Finish Rear Stainless Steel Letter Inserts, Fits all Model C6 Corvette
Corvette Attack Blue Dry Nano High Flow Filter, C8 Stingray, Z51 LT2
