C5 / C6 Corvette Restraint Racing Harness Belt Bolt-in Mounting System for 5 or 6 Point Harness, Track Day Events

Our Marrad Rear Restraint Mounting System installs under the seat tracks (oem seat tracks or our Marrad brackets with sliders) at the rear seat stud locations. It sits as far back as possible to allow seats sitting low to the floor, like our LX1 Seats, to have the most legroom without interference. It has 8 pre-drilled mounting points but more can easily be added if you preferred different spacing. We priced the part without four eye bolts, but eye bolts can be purchased separately.

Some bolt in harnesses from Schroth, Takata and others have bolt in hardware that can be bent and twisted so you may not need eye bolts if using those with this part.

 This part cannot be used along with other parts that also install around the rear seat studs, such as harness bars with struts mounting to the floor (Brey and Kraus), without modification or extended stud bolts.  We carry the Extended Stud Mounts if needed.

Optional 2, 3 or 4 Eye Bolts, Lock Washers and Nuts.

This is the best bang for your bucks to mount Lap and Sub belts in a Corvette.

Add a harness bar and you are all set to go to the track with no permanent modifications required. 

Use Snap End Clips with your Racing Harness for an easy to remove set up. Supportts 5 or 6 poinjt harness set up.

Basically this holds you in place like a Parachute harness when used with a 6 Point harness. Or run 5 Point Sub Belt under your seat and attach to center of bracket.  Continental US shipping will be approx. $18 for one $25 for two.